BEARING 5358193 - Caterpillar

Adjustment of the Oil Change Interval
Note: Your Cat dealer has additional information on this program.Program B
Optimizing Oil Change IntervalsBegin with a standard oil change interval. The oil change intervals are adjusted by increments. Each interval is adjusted an additional 50 hours. Periodic oil sampling and analysis are done during each interval. The analysis includes oil viscosity and infrared (IR) analysis of the oil. Repeat Program B if you change the application of the machine.If an oil sample does not pass the analysis, shorten the oil change interval.References
Reference: Form, PEDP7035, "Optimizing Oil Change Intervals"Reference: Form, PEDP7036, "S O S Fluid Analysis"Reference: Form, PEHP7076, "Understanding the S O S Oil Analysis Tests"Procedure for Changing the Engine Oil and Filter
Hot oil and components can cause personal injury.Do not allow hot oil or components to contact skin.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00477616If the machine is equipped with a high speed oil change, use a 126-7539 Nozzle.
Illustration 2 g00490801
Remove two bolts in order to remove the crankcase drain access cover, which is in the crankcase guard.
Remove the 090-9019 Pipe Plug from the drain valve, if equipped.
Install a 25.4 mm (1.00 inch) pipe into the drain valve. The pipe requires a 1-11 1/2 NPTF pipe thread.
Illustration 3 g00477682
Open the drain valve. Allow the oil to drain into a suitable container. A drain hose may be attached to the pipe to aid in draining.
When the oil has completed draining from the crankcase, close the drain valve. Remove the pipe. Install the 090-9019 Pipe Plug. Install the access cover.
Illustration 4 g00582388
Open the lower access cover on the right side of the engine.
Illustration 5 g00477684
Remove the engine oil filter element and discard the engine oil filter element properly. Make sure that all of the old filter seal is removed from the filter base.
Apply a thin coat of oil to the seal on the new filter. Install the new engine oil filter element by hand. When the gasket contacts the filter base, tighten the filter element by an additional 3/4 turn of 270 degrees. Rotation index marks are on the new filter element. These rotation index marks are spaced at 90 degree intervals. Use these rotation index marks as a guide for proper tightening.
Illustration 6 g00477689
Remove the oil filler cap (1). Fill the crankcase with new oil. See Operation and Maintenance Manual, "Capacities (Refill)". Clean the oil filler cap and install the oil filler cap.
Always measure the oil level with dipstick (2) in order to ensure that the correct amount of oil was added.
Check the "LOW IDLE" side of the dipstick (2) while the engine is running. The oil should be at operating temperature.