BEARING 5367903 - Caterpillar

Illustration 33 g00792300
The Location of bolts (113), bolts (111), bolts (111A), and nuts (114) .
Remove bolts (111), bolts (111A), screws (113), nuts (114), the washers, bracket (108), bracket (110), wiring (106), bracket (107), the clip and tube assembly (112) from the cover.
Remove cover (109) from the front housing.
Illustration 34 g00792321
Remove two bolts (116), the two washers, clip (119), and plate (117). Cut the tie straps in order to release wiring (115) .
Remove bolts (118), the washers, and bracket (120) from the engine.
Illustration 35 g00792396
Remove bolt (122), the washer, bolt (125), and the washer. Move bracket (121), clamp (123), and wiring harness (124) away from the engine.
Illustration 36 g00792397
Disconnect wiring harness (126) from the cylinder head.
Illustration 37 g00792408
Disconnect wiring (127) and (128) .
Illustration 38 g00792571
Remove four bolts (129), the four washers, the two clips, and the three spacers. Move the fuel filter mounting bracket out of the way.
Illustration 39 g00792572
Disconnect hose assembly (130) from the cylinder head.
Illustration 40 g00792579
Disconnect hose assembly (131). Cut tie straps (132) in order to release the wiring.
Illustration 41 g00792628
Loosen clamps (133) and (134). Remove hoses (135) and (136). Move the hoses out of the way.
Illustration 42 g00792630
Cut the tie strap and disconnect wiring (137) .
Illustration 43 g00792700
Illustration 44 g00792701
Remove fastener assemblies (139) and valve mechanism covers (138) from valve cover base (140) .
Remove bolt (142), the washer, clamp (143), and speed sensor (144) from the front housing.
Remove cylinder head (141). Use the following Steps in order to remove the cylinder head.
Remove the base for the valve mechanism cover. Refer to Disassembly and Assembly, RENR1364, "Valve Mechanism Cover Base - Remove and Install" for the correct procedure.
Remove the rocker arm and the rocker arm shaft. Refer to Disassembly and Assembly, RENR1364, "Rocker Arm and Shaft - Remove" for the correct procedure.
Remove the Electronic Unit Injector. Refer to Disassembly and Assembly, RENR1364, "Electronic Unit Injector - Remove" for the correct procedure.
Remove the camshaft gear. Refer to Disassembly and Assembly, RENR1364, "Camshaft Gear - Remove and Install" for the correct procedure.
Remove the cylinder head. Refer to Disassembly and Assembly, RENR1364, "Cylinder Head - Remove" for the correct procedure.