BEARING- 5383106 - Caterpillar

Illustration 1 g03706469
Table 1
Specification For 307-4714 Final Drive Gp    
Item     Qty     Part     Specification Description    
Make sure that there is metal to metal contact between the retainer and the hub before the bolts are tightened.    
Make sure that there is metal to metal contact between the plate and the shaft before the bolts are tightened. Then make sure that the plate is flush with the carrier. Make sure that the gears can be rotated by hand. If the gears cannot be rotated by hand, guide the covers toward the carrier with the proper tooling.    
1     1     6Y-0859 Duo-Cone Seal Gp (1)     The rubber toric seals and all the contacting surfaces must be clean and dry at assembly. Before assembly, apply a thin film of oil to the contacting surfaces of the metal seal rings. The metal seal rings must be assembled square. The rubber toric seals should not bulge and the rubber toric seals should not twist.    
2     16     034-3557 Locking Bolt     Torque to
50 10 N m (37 7 lb ft).    
3     15     5K-8454 Bolt     Torque to
135 20 N m (100 15 lb ft).    
4     29     7X-0366 Bolt     Torque to
430 60 N m (317 44 lb ft).    
5     1     6V-3298 Magnetic Plug     Torque to
225 20 N m (166 15 lb ft).    
6     1     9S-4185 O-Ring Plug     Torque to
80 8 N m (59 6 lb ft).    
7     1     7X-4777 Lip Type Seal     Lubricate the sealing lip of the lip type seal with the lubricant that is being sealed.    
Installation depth of the lip type seal from the face of the retainer (B) is
0.50 0.40 mm (0.019 0.016 inch).
( 1 ) Refer to Special Instruction, SEHS8364, "Assembly and Installation of Conventional Duo-Cone Seals"