BEARING G REPL 5F1081 - Caterpillar

Removal Procedure
Start By:
Remove the alternator. Refer to Disassembly and Assembly, "Alternator - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hot coolant, steam and alkali.At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.Remove cooling system pressure cap slowly to relieve pressure only when engine is stopped and cooling system pressure cap is cool enough to touch with your bare hand.Do not attempt to tighten hose connections when the coolant is hot, the hose can come off causing burns.Cooling System Coolant Additive contains alkali. Avoid contact with skin and eyes.
Drain the coolant from the cooling system into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
Illustration 1 g01142182
Remove bolts (2) .
Position air conditioner compressor (1) out of the way.
Illustration 2 g00860042
Remove bolts (3) .
Remove bolts (4) and remove bracket (5) .
Illustration 3 g01141760
Loosen hose clamps (6). Disconnect hoses (7) and hose (8) .
Illustration 4 g01141761
Loosen hose clamps (9) and disconnect hose (10) .
Illustration 5 g01141762
Remove bolts (11) and remove water pump (12) .