BEARING 5F5187 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     3S-6224     Electric Hydraulic Pump Gp (1)     1    
1M-6756 Sleeve (2)     1    
246-2386 Bearing Puller Plate     1    
6V-3175 Double Acting Cylinder     1    
9U-6832 Nut     1    
165-3790 Puller Stud     1    
( 1 ) 8S-8033 Electric Hydraulic Pump (230 Volt) is available.
( 2 ) This part is not required during the installation procedure.Start By:
Remove the boom. Refer to Disassembly and Assembly, "Boom - Remove".
Illustration 1 g00479266
Remove lip type seal (1) .
Illustration 2 g00479267
Use Tooling (A) to remove the sleeve bearing.
Repeat Steps 1 through 2 in order to remove the lip type seal and the sleeve bearing from the other side of the boom.Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     3S-6224     Electric Hydraulic Pump Gp     1    
9U-6227 Bearing Puller Adapter     1    
6V-3175 Double Acting Cylinder     1    
9U-6832 Nut     1    
165-3790 Puller Stud     1    
B     1P-0520     Driver Gp     1    
C     5P-0960     Molybdenum Grease     1    Note: Make sure that the bores for the sleeve bearings are free of paint and of grease prior to the installation of the sleeve bearings.
Coat the sleeve bearing and the bearing bore with Tooling (C) prior to the installation of the sleeve bearing in the bore.Note: Make sure that the sleeve bearings are installed in the bore so that the identification numbers of the sleeve bearings are facing outward.
Illustration 3 g01031887
(W) 9.5 0.8 mm (.37 .03 inch) (X) Boom (Y) Bearing
Lower the temperature of the sleeve bearings. Use Tooling (A) to install the sleeve bearing in the pin bore at the foot of the boom. Install the sleeve bearing to the depth of Dimension (W) .
Illustration 4 g00479266
Use Tooling (B) to install lip type seal (1) with the sealing lip toward the outside of the boom. Install the lip type seal until the lip type seal makes contact with the sleeve bearing.
Repeat Steps 1 through 3 in order to install the sleeve bearing and the lip type seal on the other side of the boom.
Apply a thin layer of Tooling (C) on the sleeve bearings and on the lips of lip type seals (1) before installation of the boom.End By: Install the boom. Refer to Disassembly and Assembly, "Boom - Install".