BEARING 5J8627 - Caterpillar

Removal Procedure
Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect". Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Drain the hydraulic oil into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Refill Capacities".
Illustration 1 g01153352
Remove panel (1).
Illustration 2 g01154553
Disconnect hose assemblies (2) and (3).
Illustration 3 g01154554
Remove bolts (4), bolts (5), and the spacers in order to disconnect bracket (6).
Illustration 4 g01154555
Disconnect hose assembly (7).
Illustration 5 g01154556
Disconnect hose assemblies (8) and (9).
Illustration 6 g01154557
Remove bolt (10) in order to disconnect bracket (11).
Illustration 7 g01154558
Disconnect oil fill tube (13) from block (12). Place oil fill tube (13) aside.
Illustration 8 g01154559
Illustration 9 g01155754
Remove bolts (14), bolt (15), and piston pump (16).