BEARING AS-ROLLER 6C2310 - Caterpillar

Table 1
Required Tools
Tools Part No Description Qty
A(1) 198-4234 Digital Indicator 1
198-4236 Adapter Cable As 2
B(1) 198-4238 Pressure Sensor Gp (0-35000 kPa) (0-5000 psi) 2
C 348-5430 Multi-Tool Gp 1
D NA Overhead Crane 1135 kg (2500 lb) 1
E NA Lifting Chain 2
(1) Tool (A), and Tool (B) are part of the 198-4240 Digital Pressure Indicator Gp.
Drive the machine to a smooth, horizontal surface.
Illustration 1 g02927617
Move propel lever (1) to the NEUTRAL position.
Move parking brake switch (2) to the ON position.
Illustration 2 g02927618
Use throttle control switch (3) in order to operate the engine in ECO mode or in low idle. Note: Two things indicate when the engine is in ECO mode. First, "ECO" will appear on the display. Second, the second LED next to throttle control switch (3) will be illuminated. Two things indicate when the engine is at low idle. First, "Low Idle" will appear on the display. Second, the first LED next to the throttle control switch will be illuminated.
Illustration 3 g02927619
Depress blade control button (4) to the FLOAT position. Lower the blade to the ground.
Illustration 4 g02927620
Move engine start switch (5) to the OFF position.
Assemble Tool (A). Connect Tool (B) to Tool (A).
Illustration 5 g02927621
Connect one Tool (B) to pressure tap (6). Connect second Tool (B) to pressure tap (7).
Illustration 6 g02927624
Attach Tool (D) and Tool (E) to the blade.
Move engine start switch (5) to the START position. Release the switch when the engine starts.
Operate the engine at low idle for a few minutes. Depress throttle control switch (3) in order to operate the engine in high idle. Note: Two things indicate when the engine is at high idle. First, "High Idle" will appear on the display. Second, the third LED next to throttle control switch (3) will be illuminated.
Monitor the hydraulic oil temperature with Tool (C). Operate the machine until the oil temperature reaches 38 °C (100 °F).
Illustration 7 g02927625
Depress blade control button (8) in order to lower the blade. Continue to hold the blade control in the LOWER position until the blade reaches the ground.
Raise Tool (D) in order to apply pressure to the overload valve.
Use Tool (A) in order to determine the pressure differential between pressure tap (6) and pressure tap (7). The pressure differential should be 6600 300 kPa (960 44 psi).
Depress blade control button (4) to the FLOAT position. Lower the blade to the ground.
Use throttle control switch (3) in order to operate the engine in ECO mode or in low idle. Note: Two things indicate when the engine is in ECO mode. First, "ECO" will appear on the display. Second, the second LED next to throttle control switch (3) will be illuminated. Two things indicate when the engine is at low idle. First, "Low Idle" will appear on the display. Second, the first LED next to the throttle control switch will be illuminated.
Move engine start switch (5) to the OFF position.
If the pressure differential measured in Step 15 is inside the specified range, go to Step 23. If the pressure