BEARING 6J5383 - Caterpillar

Articulated Truck: AllAsphalt Paver: AllBackhoe Loader: AllCold Planer: AllCompact Wheel Loader: AllEarthmoving Compactor: AllExcavator: AllIntegrated Toolcarrier: AllLandfill Compactor: AllLoad Haul Dump: AllMaterial Handler: AllMini Hydraulic Excavator: AllMotor Grader: AllMulti Terrain Loader: AllOff-Highway Truck/Tractor: All 777G (S/N: RDR1-UP)Paving Compactor: AllPipelayer: AllRoad Reclaimer/Soil Stabilizer: AllSkid Steer Loader: AllSoil Compactor: AllTelehandler: AllTrack-Type Loader: AllTrack-Type Skidder: AllTrack-Type Tractor: AllUnderground Articulated Truck: AllWheel Dozer: AllWheel Loader: AllWheel Skidder: AllWheel Tractor-Scraper: AllMobile Hydraulic Power Unit: 325D MHPU (S/N: C3N1-UP) 336E MHPU (S/N: T3Z1-UP) 349E MHPU (S/N: S3P1-UP)Introduction
This document provides information about the operation of Product Link PL121SR.Foreword
This document is a supplement to the machines Operation and Maintenance Manual. This document must be attached permanently to the machines Operation and Maintenance Manual.Safety Section
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Cat dealer for replacement manuals. Proper care is your responsibility.
Operation of the machine and the maintenance of the machine must not occur unless the instructions and warnings in the machines Operation and Maintenance Manual have been read and the instructions and the warnings are understood. The contents of this document must be understood before a machine that is equipped with the Product Link PL121SR is operated.Safety Messages
Illustration 1 g01370917
230-1340 Film Note: This warning film can be found in a location such as the dash that is clearly visible to the operator during the normal operation of the machine.
This machine is equipped with a Caterpillar Product Link communication device. When electric detonators are used, this communication device should be deactivated within 12 m (40 ft) of a blast site for satellite-based systems and within 3 m (10 ft) of a blast site for cellular based systems, or within the distance mandated under applicable legal requirements. Failure to do so could cause interference with blasting operations and result in serious injury or death.In cases where the type of Product Link module cannot be identified, Caterpillar recommends that the device be disabled no less than 12 m (40 ft) from the blast perimeter.
The blast site is defined as the area that handles explosive material during loading. The blast site includes the perimeter that is formed by the loaded blast holes.If the machine is required to work in or near a blasting site, then the operator must disable the Product Link PL121SR. One of the following methods are suggested in order to deactivate the Product Link PL121SR:
Install a Product Link disconnect switch in the machine cab that will allow the Product Link PL121SR module to be shut off. Refer to Special Instruction, REHS2365, "An Installation Guide for the Product Link PL121SR and for the PL300" for more details and installation instructions.
Disconnect the Product Link PL121SR module from the main power source by disconnecting the wiring harness at the Product Link module.Other Films
Illustration 2 g01787075
The film in Illustration 2 can be found in a location such as the dash.