BEARING 6V5264 - Caterpillar

Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 9 g00559429
Typical example
Illustration 10 g00559431
Typical example
Position water manifold (6) with a new gasket on the cylinder head. Install bolts (9) .
Use Tool (A) to install coolant temperature sensor (8) in water manifold (6). Tighten coolant temperature sensor (8) to a torque of 20 3 N m (15 2 lb ft). Connect the connector for coolant temperature sensor (8) .
Illustration 11 g00559403
Typical example
Use Tool (B) to install lip type seal (5) in regulator housing (3). Ensure that lip type seal (5) is fully seated in the counterbore of regulator housing (3) .
Illustration 12 g00559396
Typical example
Install water temperature regulator (4) in regulator housing (3) .
Illustration 13 g00559394
Typical example
Position regulator housing (3) with a new gasket on the water manifold. Install bolts (3). Tighten bolts (3) to a torque of 50 9 N m (37 7 lb ft).
Position hose clamps (3) and tighten the clamps to a torque of 9 3 N m (80 27 lb in).Note: Refer to Specifications, "Water Lines" for more information on the position of hose clamps (3) .
Connect the upper radiator hose to the water manifold.
Fill the cooling system to the correct coolant level. Refer to Operation and Maintenance Manual, "Refill Capacities" in the Maintenance Section for more information.Installation Procedure (Type 2)
Table 3
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1P-0510     Driver Group     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 14 g00559780
Typical example
Illustration 15 g00559806
Typical example
Use Tool (A) to install lip type seal (6) in regulator housing (4). Ensure that lip type seal (6) is fully seated in the counterbore of regulator housing (4) .
Illustration 16 g00559777
Typical example
Install water temperature regulator (5) in regulator housing (4) .
Illustration 17 g00559775
Typical example
Position regulator housing (4) with a new gasket on the cylinder head. Install bolts (2) and tighten bolts (2) .
Install the O-ring seal and a new gasket on elbow (3). Lubricate the O-ring seal with a small amount of glycerin. Install elbow (3) in the water pump. Install bolts (1) and tighten bolts (1) .
Connect the upper radiator hose to regulator housing (4) .
Fill the cooling system to the correct coolant level. Refer to Operation and Maintenance Manual, "Refill Capacities" in the Maintenance Section.