BEARING 6V9275 - Caterpillar

Required Tools
Illustration 2 g02571852
Tooling (A) 198-4240 Digital Pressure Indicator Gp
Table 3
Tool    Item    Qty    Part No    Description    
A         198-4240     Digital Pressure Indicator Gp    
    A1     1     198-4234     Digital Indicator    
A2 1     198-4237     Pressure Sensor Gp
(0 to 3,445 kPa (0 to 500 psi))    
A2 1     198-4238 (1)     Pressure Sensor Gp
(0 to 34,450 kPa (0 to 5,000 psi))    
A2 1     198-4239     Pressure Sensor Gp
(0 to 41,368 kPa (0 to 6,000 psi))    
A2 1     251-9600 (2)     Pressure Sensor Gp
(0 to 68,900 kPa (0 to 10,000 psi))    
A3 1     198-4236     Adapter Cable As    
( 1 ) This sensor must be purchased separately. The sensor is not included in the 198-4240 Digital Pressure Indicator Gp
( 2 ) This sensor can only be used on large diameter pressure taps like 6V-3965 Fitting .Test Preparation
Refer to Testing and Adjusting, "Machine Preparation for Troubleshooting".Refer to Testing and Adjusting, "System Pressure Release".
Illustration 3 g02699498
Move steering frame lock to the LOCKED position.
Engage the parking brake. Move the transmission direction selector to the NEUTRAL position.Test Procedure
Illustration 4 g03446258
Steering Pump Pressure Tap. Cab Assembly removed for clarity. (2) Pressure tap for the steering pump pressure
Attach a 0 to 25000 kPa (0 to 3600 psi) pressure gauge to pressure tap (2). Pressure tap (2) is located on the right side of the machine.
Start the engine. Operate the engine at high idle. Continuously stall the RACK BACK function while simultaneously raising the lift arms at full speed. When the lift arms are almost raised, cycle the tilt cylinder almost to the FULL DUMP position. Then move the tilt cylinders to the full RACK BACK position. Continuously stall the RACK BACK function and simultaneously lower the lift arms back to the ground level position. Without stalling the RACK BACK function, cycle the lift function to raise the lift arms fully. Then lower the lift arms in order to allow the pump to operate at low-pressure briefly and circulate oil through the system. Repeat this process in order to increase the temperature of the oil to normal operating temperature.
After the oil has reached normal operating temperature, position the bucket and any attachments slightly off the ground. Run the engine at high idle.Note: During the following step, do not keep the steering pump at stall condition for more than 10 seconds. If necessary, release the steering wheel and wait for 30 seconds before you repeat the step.
Turn the steering wheel to the FULLY TURNED position in order to obtain a reliable pressure reading.
Record the pressure reading on the pressure gauge. The reading should be 20700 700 kPa (3002 102 psi).
Adjust the pressure compensator valve if the steering system pressure is not correct.
Stop the engine. Lower the bucket and any attachment to the ground.
Remove the hydraulic line and the pressure gauge from pressure tap (2) .Adjustment Procedure (High Pressure Cut-off)
Illustration 5 g02923379
(3)