BEARING-ROLLER 6V9770 - Caterpillar

Disassembly Procedure
Remove the starting motor from the machine. The procedure for removal of the starting motor may vary slightly with a different series of starting motor.
Illustration 1 g00718892
Disconnect the field winding strap (2) from the solenoid assembly (1) .
Illustration 2 g00718893
Disconnect the solenoid plunger and remove the solenoid plunger (3) from the shift lever. To remove the plunger, lift the plunger slightly.
Illustration 3 g00718894
Scribe a line on the drive and the starting motor housings for proper alignment at assembly. Remove the end cover nuts (5) and the washers. Remove the shift lever nut (4), the washer, and the screw.
Illustration 4 g00718897
Separate the two halves of the starting motor. It may be necessary to remove one stud (8) from the drive housing in order to remove the shift lever assembly (7) and drive housing assembly (6). Do not damage the seal.
Illustration 5 g00719540
If necessary, remove the bushing (9) from the drive housing.
Illustration 6 g00718898
Remove the seal (11) from the ring with a suitable sleeve. Remove the ring, the seal (11), and the pinion drive assembly (10) from the armature.
Remove the bearing assembly (12) .
Illustration 7 g00718899
Remove the seal (13) and remove the bushing from the bearing assembly, if necessary.
Illustration 8 g00718901
Remove the two screws and the center cover from the end cover assembly. Remove the seal.
Remove the C washer (15) from the end of the armature. Remove the shims (16) from the end of the armature.
Remove the end cover assembly (14) .
Illustration 9 g00719542
Remove the bushing (17) from the end cover, if necessary.
Illustration 10 g00718902
Remove the armature assembly (19) from the starting motor housing and the brush holder assembly (18) .
Illustration 11 g00718908
Unsolder the field winding leads from the positive brush leads. Remove the brush holder assembly (18). Unsolder the negative brushes from the brush holder, if necessary.
Remove the screws (21) from the starting motor housing. Remove the field winding assembly (20) from the starting motor housing. Use an impact driver to remove the screws (21), if necessary.
Do not use a liquid cleaning agent to clean the armature assembly, field winding (coil) assembly, or pinion drive assembly. Liquids can damage these parts. Use only compressed air to clean them.
Personal injury can result from air pressure.Personal injury can result without following proper procedure. When using pressure air, wear a protective face shield and protective clothing.Maximum air pressure at the nozzle must be less than 205 kPa (30 psi) for cleaning purposes.