BEARING-SLEEVE 6W6306 - Caterpillar

The AccuGrade system consists of the following components:
Display
Light Bars
GPS Receivers
Radio
Power Supply Module
Pitch Sensor
Angle SensorsDisplay
The AccuGrade GPS display is a computer that runs the software for the AccuGrade system. This section describes the operation of the display.The display is used in order to operate the AccuGrade system. The display has a color LCD Screen (1) in order to show information and a keypad for entering information. Refer to Illustration 1.
Illustration 1 g01383169
AccuGrade GPS Display (1) LCD Screen (2) Soft Key Labels (3) Soft Keys (4) Next Key (5) Escape Key (6) Slot for Data Card (7) Power Key (8) Menu Key (9) Arrow Keys (10) OK Key (11) Zoom out Key (12) Zoom in KeyContact Description Of The Display
Illustration 2 g01455574
Table 1
Pin    Function    
A     BEEPER GND    
B     SW TCH INPUT 0    
C     RESERVED    
D     BATTERY +    
E     BATTERY +    
F     BATTERY    
G     BATTERY -    
H     RESERVED    
J     CAN L0    
K     CAN H0    
L     CAN H1    
M     CAN LL    
N     RS232-TXD 2    
P     RS232-RXD 2    
R     RS232-SGND 2    
S     RS232-SGND 1    
T     RS232-RXD 1    
U     RS232-TXD 1    
V     RESERVED    
W     RESERVED    
X     BEEPER    
Y     SWITCH INPUT 1    
Z     RESERVED    
a     RESERVED    
b     RESERVED    
c     RESERVED    
d     CAN SHIELD 0    
e     CAN SHIELD 1    
f     RS-232 RTS 0    
g     RS-232 CTS 0    
h     RS-232 RXD 0    
I     RS-232 TXD 0    
j     RESERVED    
k     SWITCH INPUT 2    
m     CHASSIS GND    
n     AWAKE GND    
p     AWAKE    
q     RS-232 SGND 0    
r     CHASSIS GND    Power Key
Press the power key (7) in order to turn on the display.Press the power key and hold the power key (7) for several seconds in order to shut down the display. This delay reduces the risk of inadvertently shutting off the power. You can turn off the AccuGrade system from any screen or from any dialog.Data Card And Data Storage
The contents of the data card, or the data card itself, may be damaged if the card is removed from the card slot immediately after the card slot door is opened. When a data card is in the card slot, and the card slot door is opened, a full screen warning message on a red background is displayed. Wait until the warning message disappears before removing the card.
Construction designs are developed in the office. The AccuGrade Office V6.1 or greater software is used in order to convert construction designs into a format that is easily read by the AccuGrade system. The software interprets the designs. The software uses the AccuGrade display and the light bars in order to guide your position while