BEARING-IDLER 6Y8023 - Caterpillar

Record the following information before you change any programmable parameter.
Table 1
Equipment ID        
Engine Serial Number        
Serial number for Electronic Control Module (ECM)        
"Full load setting (FLS)"        
"Full torque setting (FTS)"        
Fuel Ratio Control (FRC) Offset        
Rated Fuel Position        
Low Idle Speed        
High Idle Speed        
Fuel Correction Factor        
Engine Cooling System        
Identifier for Cat Data Link        
Cold Mode Cylinder Cutout        
Cooldown Speed        
Engine Cooldown Duration        
Engine Acceleration Rate        
Intermediate Speed        
Engine Prelube Duration        
Crank Duration        
Maximum Number Of Crank Cycles        
Crank Terminate Speed        
Air Shutoff        
Air Inlet Shutoff Detection        
Cooling Warning Engine Load Enable        
Ether Control        Injector Trim Code
Table 2
Injector Trim Code    
Injector    Trim Code    
"Inj #1 e-trim"        
"Inj #2 e-trim"        
"Inj #3 e-trim"        
"Inj #4 e-trim"        
"Inj #5 e-trim"        
"Inj #6 e-trim"        
"Inj #7 e-trim"        
"Inj #8 e-trim"        
"Inj #9 e-trim"        
"Inj #10 e-trim"        
"Inj #11 e-trim"        
"Inj #12 e-trim"        
"Inj #13 e-trim"        
"Inj #14 e-trim"        
"Inj #15 e-trim"        
"Inj #16 e-trim"        Record the following information from the engine monitoring system. The engine monitoring system can be accessed through the Caterpillar Electronic Technician (ET). Select "Monitoring System" from the "Service" menu.Low System Voltage
Table 3
Warning Trip Points        
Warning Delay Time        Low Engine Oil Pressure
Table 4
Warning Trip Point        
Warning Delay Time        
Shutdown Trip Point        
Shutdown Delay Time        High Coolant Temperature
Table 5
Warning Trip Point        
Warning Delay Time        
Derate Trip Point        
Derate Delay Time        
Shutdown Trip Point        
Shutdown Delay Time        Low Coolant Temperature
Table 6
Warning Trip Point        
Warning Delay Time        Engine Overspeed
Table 7
Warning Trip Point        
Warning Delay Time        
Shutdown Trip Point        
Shutdown Delay Time        High Air Filter Restriction Pressure
Table 8
Warning Trip Point        
Warning Delay Time        
Derate Trip Point        
Derate Delay Time        Altitude (Atmospheric Pressure)
Table 9
Derate Trip Point