BEARING-SLEEVE 7D3807 - Caterpillar

Engines:
G3606 (S/N: 3XF)
G3608 (S/N: 4WF)
G3612 (S/N: 1YG)
G3616 (S/N: 4CG)
Engine News SEBD9299, July 2001, "A New Accumulator Is Used In The Hydrax System". Disregard this article. This article included some incorrect part numbers in Tables 1 and 2. This article has been replaced by the following article.Description of Change: A new accumulator is used in the Hydrax System on these engines. The new accumulator includes the improvements that follow:
A new design for the charging valve
A variable volume that is controlled by an internal piston
A larger volume provides hydraulic pressure for a longer period of time.Adaptable To: The new accumulator can be installed on any G3600 Engine that is currently operating with the Hydrax System.Instructions For Converting G3606 And G3608 Engines To The New Style Of Accumulator
The table identifies the components that are required to convert a G3606 Engine or a G3608 Engine to the new style of accumulator.
Table 1
Components That Are Required For A G3606 Engine Or A G3608 Engine        
Qty    Part Number    Description        
1     201-9561     Accumulator        
1     198-7778     Bracket        
2     170-0990     Clamp        
4     126-3005     Pipe        
4     9S-8752     Nut        
4     1A-5183     Bolt        
12     3V-3308     Hard Washer        
4     0S01590     Bolt        
1     6V-8637     Seal Connector        
2     6V-9746     O-Ring Seal        
1     3D-2824     O-Ring Seal        
Illustration 1 g00807585
This view is of the left side of the engine. This view shows the former accumulator. (1) 130-1498 Accumulator (2) Support Clip and Bracket (3) Hardware (4) Tube Assembly (5) 131-7746 Bracket (6) Filter and filter base
Shut down the engine.
Disconnect tube (4) from the end of the accumulator (1) .
Remove the hardware (3). Remove the support clip and bracket (2). Remove the accumulator (1) .
Remove the filter and the filter base (6) from the bracket (5) .
Remove the bracket (5) .
Illustration 2 g00807610
This view is of the left side of the engine. This view shows the new accumulator. (4) Tube Assembly (6) Filter and filter base (7) Charging Valve (8) Protective Cover (9) 201-9561 Turbocharger Oil Accumulator Gp (10) 170-0990 Clamps (11) 1A-5183 Bolts and 3V-3308 Hard Washers (12) 126-3005 Pipes (13) 6V-8637 Seal Connector (14) 9S-8752 Full Nut and 3V-3308 Hard Washers (15) 198-7778 Bracket
Install the bracket (15) with the existing hardware.
Loosely install the filter and filter base (6) with the existing hardware. Loosely connect the lines to the filter base. After the components are in alignment, tighten the filter base in position and tighten the lines in position.
Install the 3D-2824 O-Ring Seal and Seal Connector (13) in