BEARING-CONNECTING ROD 7E0558 - Caterpillar

Refer to SEBU6498, the 3306B Generator Set Engine Operation and Maintenance Manual, for basic engine start/stop/operation procedures.Perform these checks before operating the engine and generator.
Typical fuel gauge, located in the base inside of the enclosure.* Check the fuel level. The fuel tank capacity of the XQ225 Rental Generator Set is 530.6 L (140 US gal). The full load maximum fuel consumption for the XQ225 Rental Generator Set is approximately 66.2 L/hour (17.5 US gal/hour). Refer to SEBU6498, the 3306B Operation and Maintenance Manual, for the proper lubrication oil and coolant.
Coolant filler cap (1), oil filler cap (2), and oil level gauge (dipstick) (3). * Check the oil level with the engine stopped. The oil level should be between the ADD and FULL marks on the ENGINE STOPPED side of the dipstick. If necessary, remove the oil filler cap and add oil. Ensure that the oil level is not above the FULL mark. Clean the oil filler cap. Clean the cap receptacle. Install the cap.* Check the coolant level with the engine stopped and cool. Remove the coolant filler cap slowly to relieve any pressure. Maintain the coolant level within 13 mm (1/2 inch) below the bottom of the fill pipe. Clean the coolant filler cap. Inspect the cap. Replace the cap if the gaskets are damaged. Clean the coolant filler cap receptacle. Install the cap.Load Connection Procedure
Distribution Panels
Dual voltage distribution panel (1) and single voltage distribution panel (2).The dual voltage distribution panel (240V and 480V) is equipped with HIGH and LOW voltage main circuit breakers. This panel is equipped with HIGH and LOW voltage main load connections. The main load connections do not require changeover or switching.The single voltage distribution panel (600V) is equipped with a single voltage main circuit breaker and a single voltage main load connection.
Contact with loose connectors can result in electrical shock and may cause injury or death.
Verify the correct load phase rotation with the generator prior to connecting the output power cables.
The load connection procedure is illustrated with a dual voltage distribution panel. All of the instructions are typical for both the dual voltage distribution panel and the single voltage distribution panel.
Circuit breakers (1), receptacles (2), buss bars (3), reinforcement bar (4), remote start/stop connection points (5), and ground connection (6).1. Ensure that the generator set is not operating. Place main circuit breaker(s) (1) in the OFF (open) position.For dual voltage distribution panels, determine HIGH (480V) or LOW (240V) voltage use. Select the applicable voltage main load connectors (2) or (3).2. Connect the output power cables to receptacles (2) or to buss bars (3).If it is necessary to connect the output power cables to the buss bars:2a. A clear plastic shield covers the buss bars. Remove the clear plastic shield. Removing the shield activates the shutoff switch. Remove reinforcement bar (4).2b. Connect the output power cables to buss bars (3).2c. Install reinforcement bar (4). Install the clear plastic shield. The unit will not operate unless the shield is properly installed. Torque all