BEARING 7G1952 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 5P-0332 Crowfoot Wrench 1
Contact with high pressure fuel may cause personal injury or death. Wait 60 seconds after the engine has stopped to allow fuel pressure to purge before any service or repair is performed on the engine fuel lines.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service instructions may cause personal injury or death.
Illustration 1 g01445061
Illustration 2 g01445062
Remove tube assembly (3).
Remove fitting (2). Note: Relief valve (1) is a two-piece valve which should not be disassembled.Note: Do not use Tooling (A) at Location (X).
Use Tooling (A) to remove relief valve (1). Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 5P-0332 Crowfoot Wrench 1
B 161-9203 Grease Cartridge 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g01445061
Illustration 4 g01445062Note: Relief valve (1) is a two-piece valve which should not be disassembled. Note: Do not use Tooling (A) at Location (X).
Apply Tooling (B) to the threads and face of relief valve (1).
Install relief valve (1). Use Tooling (A) to tighten relief valve (1) to a torque of 95 3 N m (70 2 lb ft).
Install fitting (2).
Install tube assembly (3).