BEARING-ROLLER 7I7619 - Caterpillar

Illustration 1 g00734575
Note: Once the clutch has been installed onto the engine, hit the output shaft sharply on the end. This is done in order to relieve any preload. (1) Bearing adjustmentUse the following procedure for the bearing adjustment:
Tighten the bearing retainer until 6.8 N m (60.1851 lb in) is required to rotate the shaft. Shims are not used during this step.
Measure the shim gap and add 0.33 mm (0.0130 inch) in order to obtain the proper shim thickness.
Assemble the shims and the retainer. Refer to the Table 1 for the appropriate shims to use.
Table 1
Shim Table    
Part number     Thickness    
5L-3556    
0.5080 mm (0.020 inch)    
5L-3557    
0.2540 mm (0.010 inch)    
5L-3558    
0.1778 mm (0.0070 inch)    
5L-3559    
0.1270 mm (0.0050 inch)    
The end play is 0.15 to 0.25 mm (0.006 to 0.010 inch).Clutch Engagement Check On The EngineA torque of 295 to 395 N m (218 to 291 lb ft) on the splined clutch shaft is required in order to engage the clutch.