BEARING 7K9262 - Caterpillar

Improper lifting or tiedowns can allow load to shift and can cause injury and damage.
Illustration 1 g00130703
The weights and measurements that are listed in Table 1 and the instructions that are listed below describe the units that are manufactured by Caterpillar Inc.
Table 1
Machine Specifications For The 561M Pipelayer    
Approximate Ready-to-work Machine Weight    
16240 kg (35804 lb)    
Approximate Weight without the boom and without the load blocks    
15318 kg (33770 lb)    
Length    
3730 mm (147 inch)    
Width without the boom    
3193 mm (125.7 inch)    
Height without the boom    
3124 mm (123 inch)    Note: Significant deviations can affect shipping the machine, or significant deviations can affect lifting the machine. Some examples of these deviations are listed below:
Different implements
Additional fuel
Wider track shoes
Tracks with accumulated mud
The parking brake must be engaged before you sling the machine. Be sure that the parking brake is engaged before you secure the machine with tie-downs.
Use properly rated cables and properly rated slings for lifting. Position the slings beneath the front of the track and beneath the rear of the track.
On sharp corners, use corner protectors. The crane should be positioned so that the machine may be lifted in a level plane. The spreader bars should be wide enough to prevent contact with the machine.
Tie-down positions
Use the eye of the towing device for the front tie-down.
Use the inside edge of the track shoe for the side tie-downs.
Use the retrieval hitch or the outer edge of the track shoe for the rear tie-downs.Check the state and local laws that govern the following load characteristics.
Weight
Width
Length
HeightConsult your Caterpillar dealer for shipping instructions for your machine.