BEARING-INNER 7P9047 - Caterpillar

(24)Winch Breather
Remove and discard breather. Install a new breather.(25)Winch Oil Sump
1. Remove fill and drain plugs. Allow oil to drain. Do items 22 and 23. Clean and install drain plug. 2. Fill compartment until oil is visible in the sight gauge. Clean and install fill plug. See REFILL CAPACITIES.3. Start engine and operate at low idle. Check oil level with engine running at low idle. Maintain oil level to be visible in sight gauge.(26)Universal Joint
Remove floor plate and lubricate 2 fittings.(27)Transmission, Bevel Gear, And Steering Clutch Compartments
1. Oil should be warm before draining. Remove drain plugs from bevel gear case and flywheel housing. 2. Remove cover and screen from flywheel housing.3. Wash screen in clean solvent. Install screen and cover.4. Change filter element. Wash magnetic strainer. See item 19.5. Install bevel gear and flywheel clutch housing drain plugs. 6. Remove breather from filler cap. Install new breather. 7. Fill compartment. See REFILL CAPACITIES. Start engine and check oil level. Oil should be up to FULL mark on gauge.(28)Final Drives
1. Remove drain plugs and allow oil to drain. 2. Remove breathers. Install new breathers.3. Clean and install drain plugs. 4. Remove fill plugs and add oil to level of filler plug openings. See REFILL CAPACITIES.