BEARING INTERMEDIATE 7S8305 - Caterpillar

Specifications
Illustration 1 g02342900
Table 1
SPECIFICATIONS FOR 360-1693 Fuel Priming Pump and Primary Filter    
Callout     Part Number     Part Name     Specification Description    
2     327-8044     Check Valve     Torque to.........................
28 3 N m (21 2 lb ft)    
6     300-6908     Cartridge     Torque to.........................
6.5 0.5 N m (58 4 lb in)    
8     211-2093     Nut     Torque to.........................
28 3 N m (21 2 lb ft)    
15     179-7267     Plug     Torque to.........................
95 10 N m (70 7 lb ft)    Removal Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     185-3630     Strap Wrench As     1    
Turn the fuel supply to the OFF position and turn the power disconnect switch to the OFF.
Disconnect the harness assembly (not shown).
Illustration 2 g02342878
Drain the primary filter and use Tooling (A) in order to remove primary filter (1). Refer to Operation and Maintenance Manual, "Fuel System Primary Filter (Water Separator) Element - Replace" for the correct draining and filling procedures.
Illustration 3 g02175165
Remove check valve (2). Remove backup ring (3), O-ring seals (4) and (5) .
Illustration 4 g02175476
Remove nut (6) and remove coil (7) .
Remove cartridge (8). Remove backup ring (11), and remove O-ring seals (9) and (10) .
Illustration 5 g02175494
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Note: May need to position the oil filler out of the way.
Remove plug (15) and remove the O-ring seal. Remove spring (14), valve (12) and O-ring seal (13). Repeat this step for the other check valve assembly.
Remove the fuel priming pump. Refer to Disassembly and Assembly, "Fuel Primping Pump - Remove and Install".Installation Procedure
Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Install primary filter (1) in the reverse order.
Tighten plug (15) to a torque of 95 10 N m (70 7 lb ft).
Tighten check valve (2) to a torque of 28 3 N m (21 2 lb ft).
Tighten cartridge (8) to a torque of 28 3 N m (21 2 lb ft).
Tighten nut (6) to a torque of 6.5 0.5 N m (58 4 lb in).