BEARING 7.62 cm(3 in.) long 8D5995 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0074 Slide Hammer Puller Gp 1
4C-5655 Threaded Adapter 1
B 5P-0960 Grease Cartridge - Start By:
Release hydraulic system pressure.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Illustration 1 g02933641
Remove bolts (2), guard assemblies (1), and guard assembly (3).
Illustration 2 g02933642
Illustration 3 g02933644
Disconnect hose assemblies (10).
Attach a suitable lifting device to bulldozer lift cylinder (6). The weight of bulldozer lift cylinder (6) is approximately 45 kg (100 lb).
Remove bolt (8), retainer (7), pin (9), and the spacer.
Remove bolts (4) and cover (5). Use Tooling (A) to remove pin (11). Remove pin (11) and the spacer.
Remove bulldozer lift cylinder (6).Installation Procedure
Install bulldozer lift cylinder (6) in the reverse order of removal.
Apply Tooling (B) to pin (9) and pin (11).
Tighten bolt (8) to a torque of 105 20 N m (77 15 lb ft).
Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check" for the correct hydraulic oil level.