BEARING 8D9652 - Caterpillar

System Operation Description:This procedure covers the following codes:
Table 1
Diagnostic Trouble Codes for "Injector Data Incorrect"    
J1939 Code     Description     Notes    
651-2     Engine Injector Cylinder #01 : Erratic, Intermittent or Incorrect     The Electronic Control Module (ECM) detects an injector code that is incorrect for the engine.
If equipped, the warning lamp will come on.    
652-2     Engine Injector Cylinder #02 : Erratic, Intermittent or Incorrect    
653-2     Engine Injector Cylinder #03 : Erratic, Intermittent or Incorrect    
654-2     Engine Injector Cylinder #04 : Erratic, Intermittent or Incorrect    
655-2     Engine Injector Cylinder #05 : Erratic, Intermittent or Incorrect    
656-2     Engine Injector Cylinder #06 : Erratic, Intermittent or Incorrect    The following background information is related to this procedure:Injector codes are codes that are 30 hexadecimal characters in length that are supplied with each injector. The code is on a plate on the top of the injector and a card is also included in the packaging for the injector. The code is used by the ECM to balance the performance of the injectors.Refer to Troubleshooting, "Injector Code - Calibrate" for further information.
Illustration 1 g02131289
Typical label with an injector code
Illustration 2 g02132293
Sequence for recording the injector codeTest Step 1. Check for Diagnostic Codes That Are Related to this Procedure
Connect the electronic service tool to the diagnostic connector.
Turn the keyswitch to the ON position.
Check for active diagnostic codes that are related to this procedure.
Make a note of the active diagnostic codes.Expected Result:One or more of the diagnostic codes that are listed in Table 1 are active at this time.Results:
OK - One or more of the preceding diagnostic codes are active. Make a note of any cylinder numbers with the active diagnostic code. Proceed to Test Step 2.
Not OK - None of the preceding diagnostic codes are active at this time.STOPTest Step 2. Check the Injector Code on any Suspect Cylinders
Connect the electronic service tool to the diagnostic connector. Refer to Troubleshooting, "Electronic Service Tools".
Turn the Keyswitch to the ON position.
Select the following menu options on the electronic service tool in order to obtain the injector codes from the ECM:
"Service"
"Calibrations"
"Injector Trim Calibration"
Make a note of the injector codes for any suspect cylinders.
If the card that was supplied with the injector is available for the suspect cylinders, perform the following procedure:
Compare the injector code from the card with the injector