BEARING 8E5284 - Caterpillar

The engine is equipped with an open crankcase ventilation system. Refer to Illustration 2. The crankcase pressure sensor monitors the level of crankcase pressure. The breather routes blowby from the valve cover base to the fumes disposal tube. The breather contains a filter element. The filter element filters the blowby gasses. The fumes disposal tube vents the filtered blowby gasses to the surrounding atmosphere.Prior to troubleshooting a high crankcase pressure, perform the following procedure:
High crankcase pressure can occur if there are obstructions in the crankcase ventilation system. The maintenance section of the Operation and Maintenance Manual contains procedures for cleaning the components of crankcase ventilation system. Refer to Operation and Maintenance Manual, "Engine Crankcase Breather - Clean" and refer to Operation and Maintenance Manual, "Crankcase Fumes Fitting - Inspect/Clean".
Clear the diagnostic code. Use this procedure in order to troubleshoot a high crankcase pressure or use this procedure if one of the following diagnostic codes is active. Access the engine monitoring system on Caterpillar Electronic Technician (ET) in order to view the current trip points for these codes. Refer to Troubleshooting, "Engine Monitoring Parameters" for information about engine events.
Table 1
Engine Event
J1939 Code and Description Conditions that Generate the Code System Response
101-15 Engine Crankcase Pressure : High - least severe (1) The Engine Control Module (ECM) activates this code when the crankcase pressure has exceeded the limit for a programmed period. The amber warning lamp is illuminated. The code is logged.
This code can be caused by an obstructed tube, an obstructed filter, or an obstructed hose.
101-16 Engine Crankcase Pressure : High - moderate severity (2)
Illustration 1 g02054714
Left side engine view
(1) Crankcase pressure sensor
Illustration 2 g02213453
Components for the crankcase ventilation system
(2) Filter housings
(3) Fumes disposal tube
(4) Breathers
(5) Oil drain tube
(6) Check valve Probable Causes
Plugged crankcase breather
Faulty check valve
Faulty sensor
Worn engine componentsRecommended Actions
Crankcase Breather
A plugged crankcase breather will cause excessive crankcase pressure. Leakage of the crankshaft seal can occur. Sealing of the piston rings can be lost. An increased crankcase pressure will typically lead to an increase in the crankcase blowby. Clean the crankcase breather according to the Operation and