BEARING 8N5489 - Caterpillar

Illustration 1 g06090063
(1) Service buttonNote: A password (pass code) is required to access Configuration, Calibration, and Service Tests menus.
Press the "Service" button (1) on the right side of the Display. The Service page will appear.
Press the "Service Mode" button. A Service Mode page with a keypad will appear if Service Mode is disabled. A keypad will not appear if Service mode is already activated.
Illustration 2 g06090066
(2) OK button
(3) BACK button
To enable "Service Mode" and access Configuration, Calibration, and Service Test menus, enter a password (pass code numbers) on the keypad. Press the OK button (2).
Press the BACK button (3) to return to the previous menu.Service Mode Enabled
When Service Mode is "Enabled":
View Configurations, Calibrations, and Service Tests on the current Service Menu page.
Adjust Configuration settings and perform Calibrations and Service Tests.
Illustration 3 g03712973Service Mode Disabled
When Service Mode is "Disabled":
Configurations, Calibrations, and Service Tests will not appear on the Service Menu page. These items are inaccessible when Service Mode is disabled.
Illustration 4 g03712979Configurations
Service > Configurations
Illustration 5 g03712998Payload Configurations
Service > Configurations > Payload
Illustration 6 g03713177
Press the "Configurations" button. The "Configurations" button will highlight in yellow and the "Configurations" page will appear.
Press the "Payload" button. The "Payload" button will highlight in yellow and the "Payload" Configuration menu pages will appear.Payload Overload
Service > Configurations > Payload > Payload Overload
Illustration 7 g03713186
Press the "Payload Overload" button. The "Payload Overload" button will highlight in yellow and the "Payload Overload" settings page will appear.
Illustration 8 g06090069
Payload Overload Limit (4) is in the gray OFF position.
(4) Payload Overload Limit
Press the "Enable Payload Overload Limit" button (4). The button will turn blue, then green, and advance to the right ON position. Proceed with setting "Payload Overload Limit".
Use the Increment Bar on the page to set Payload Overload Limit.
Press the (-) arrow button on the left end of the bar to decrease the value.
Press the (+) button on the right end of the bar to increase the value.
Press the "OK" button (2) to set.
Illustration 9 g03713207
Payload Overload Limit is in the green ON position.
To turn OFF Payload Overload Limit, press the green Payload button. The button will turn gray and return to the left OFF position.
Press the BACK button (3) to return to the previous menu.Payload Target
Service > Configurations > Payload > Payload Target
Illustration 10 g06090072
(5) Data Entry button
Press the "Configurations" button. The "Configurations" button will highlight in yellow and the "Configurations" page will appear.
Press the "Payload" button. The "Payload" button will highlight in yellow and the "Payload" Configuration menu pages will appear.
Press the "Payload Target" button. The "Payload Target" button will highlight in yellow and the "Payload Target" settings page will appear.
Press the Data Entry button (5) and the "Payload Target" settings page will appear.
Illustration 11 g03713220
Type in a value for the Payload Target. Press the "OK" button to set. The new number will appear on the settings page.
Press the BACK button (3) to return to the previous menu.