BEARING 8U4853 - Caterpillar

Manual Control Shutdown Procedure
Press the "STOP" button (49) on the AGC upper display to open the generator breaker immediately, and put the engine in cooldown/stop mode. Alternately, the breaker symbol can be pressed first to unload the generator, and open the generator breaker before pressing the "STOP" button (49) . Note: Always use the AGC upper display to start/stop the engine when using manual control. Using the EMCP for startup or shutdown will result in improper equipment operation.Utility Mode/Base Load
Automatic Control Startup Procedure
Illustration 37 g03643830
Press the "AUTO" button (16) on the EMCP to put the EMCP into auto mode.
Illustration 38 g03643818
Verify "REMOTE" mode is active. If "REMOTE" mode is inactive, press the "REMOTE" button (43) on the AGC upper display.
Illustration 39 g03643939
Verify live utility source. The indicator (44) will illuminate when a live source is detected. The unit is now ready to start.
Close the remote start contact to activate the AGC digital input on all units. The engine will start, the generator will build up voltage, and the generator breaker will close automatically.
Illustration 40 g03643853
When the generator breaker closes, the two indicators, (46) and (44) will illuminate. The unit is now parallel to the utility.
The generator output power will steadily increase up to the preprogrammed level. Automatic Control Shutdown Procedure
Open the remote start contact. The unit will soft unload the generator, open the generator breaker, and put the engine in cooldown/stop mode. VFD
Illustration 41 g03790608
(77) Display status
(78) Menu line
(79) Submenus
(80) Status line
(81) Function buttons
(82) Stop/Reset button
(83) Run button
(84) Navigation button/dial
(85) FWD/REV button
(86) ESC button
(87) Scroll boxes Display status (77) - displays the default settings the state of the drive, active control channels, frequency reference and LOC/REM (T/K key status). The "Display Status" content can be configured.Menu line (78) - displays the name of the current menu or submenu.Submenus (79) - lists the submenus of the current menu.Status line (80) - displays the functions assigned to function buttons "F1-F4: Code (F1)""<<(F2)"">>(F3)""T/K (F4)".Function buttons (81) - F1: displays the code of the selected parameter, or contextual help, F2: navigates to the left, or returns to the previous menu or submenu, F3: navigates to the right, or advances to the next menu or submenu and F4: command and reference via the terminal or keypad.Stop/Reset button (82) - stops the drive controller and resets the faults when in HMI command mode.Run button (83) - runs the motor with the current setting. Starts the drive controller if in HMI command mode.Navigation button/dial (84) - pressing the button saves a value, or enters a menu or parameter. Turning the dial clockwise increases a value or advances to the next menu item or line. Turning the dial counterclockwise decreases a value or backs up to the previous menu item or line. In HMI mode, the dial acts as a speed reference control.FWD/REV button (85) - reverses the rotation direction of the motor (if configured to allow reverse for HMI command mode).ESC button (86) - exits a menu or parameter, or cancels a value to return to the previous value in