BEARING 8U7724 - Caterpillar

Installation Procedure
Note: Verify that all of the components of the STIC control and pilot valve are clean and free of foreign material prior to installation.Note: Check all of the O-ring seals and the components for wear or damage. Replace the components, if necessary. Lubricate the O-ring seals lightly with the lubricant that is being sealed.
Illustration 1 g00593241
Position STIC control and pilot valve (13) for installation. Install three bolts (12), the hard washers, and the spacer.
Illustration 2 g00593234
Connect two wiring harnesses (11) at the electrical connections.
Connect hose assembly (7), hose assembly (8), hose assembly (9), and hose assembly (10) .
Illustration 3 g00593228
Position housing (4) and housing (5) for installation.
Install ball knob (3) .
Install 13 truss head screws (6) .
Illustration 4 g00593223
Position guard assembly (1) for installation.
Install four truss head screws (2) and the spacers.End By:
Separate the frame lock link. Refer to Disassembly and Assembly, "Frame Lock Link - Separate and Connect".
Remove the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chock (Front and Rear) - Remove and Install".