BEARING-SLEEVE 9D8238 - Caterpillar

Separation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Bracket     2    Start By:
Separate the torque converter from the transmission and output transfer gears. Refer to Disassembly and Assembly, "Torque Converter from Transmission, Output Transfer Gears - Separate".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01173203
Disconnect harness assemblies (1) .
Illustration 2 g01173204
Remove tube assembly (2) .
Illustration 3 g01173205
Attach Tooling (A) and a suitable lifting device to transmission (3). The weight of transmission (3) is approximately 363 kg (800 lb).
Illustration 4 g01173206
Remove transmission (3) from output transfer gears (4) .