BEARING 9L0730 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Stud
M8 by 90 mm 2
Illustration 1 g02720529
Illustration 2 g02720548
Clean the gasket surface of front cover (6).
Install Tooling (A) in Position (X).
Use Tooling (A) in order to align new gasket (7) to front cover (6). Install the gasket onto the housing.
Align water pump (8) to Tooling (A). Install the water pump to front cover (6). Note: Ensure that the gear of the water pump and the gear of the fuel injection pump mesh.
Install bolts (9). Refer to Illustration 1. Tighten the bolts finger tight.
Remove Tooling (A) and install remaining bolts (9).
Illustration 3 g01985813
Tighten the bolts in the sequence that is shown in Illustration 3 to a torque of 22 N m (195 lb in).
Illustration 4 g02720361
Connect hoses (3), (4), and (5).
Illustration 5 g02720338
Connect tube (1).
Connect hose (2).
Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct procedure. End By:
Install the clean emissions module.