BEARING 9M4871 - Caterpillar

UPSView Commands And Hotkeys
Table 1
UPS Command Table
Name Hotkey Password Level
Enable Printing of Startup Errors \ None
Silence Display Buzzer B None
Change Display Owner to MMU 1 Alt-1 None
Change Display Owner to MMU 2 Alt-2 None
Change Redundant MMU Alt-B Service
Send System Calibration Factors Alt-C Service
Change Display Owner to this MMU Alt-D None
Ethernet Loopback Test Alt-E None
Force Op Params Alt-F Service
Report AVR Demand FPGA Reading Alt-G None
EPO Switch Status Alt-I None
Show Ethernet Statistics Alt-J None
Synchronize Event Logs Alt-L None
Dump MMU Status Registers Alt-M None
Toggle Debug Messages Alt-N Service
Toggle Op Params Sent Over Can Alt-O Service
Cancel Paging Alt-P Service
Enter Regulation Only Mode Alt-R Service
Enter AVR Spin down Mode Alt-S Service
Show Telemetry and Status Registers Alt-T None
Show B-N (or Ground) Voltage Alt-U None
Verify PCC Configuration Alt-V Service
Toggle Discharge Walk-in to Input VAC Alt-W Service
Report Op Params that are not defaults Alt-Z None
Start Genset Control-[ Service
Show Bypass Status Control-\ None
Stop Genset Control-] Service
Send Op Params Control-_ None
Send Tile Definitions Control-A None
Enter Bypass Mode Control-B Service
Send Calibration Prompt Again Control-C Service
Download Event Log Control-D None
Get Password Seed and Serial Number Control-F None
Dump IGBT Currents Control-G None
Show Hotkeys Control-H None
Load default 60 Hz Op Params to Flash Control-I Service
Show Diagnostic data Control-J Service
Toggle Discharge Disable Control-L Service
Show Revision Information Control-N None
Enter Online Mode Control-O Service
Clear View Password Control-P Service
Reset Modem NVRAM to Default Control-Q Service
Reset the Processor Control-R Service
Enter Bypass Spin down Mode Control-S Service
Toggle Vacuum Level Checking Control-V Service
Toggle Modem On/Off Hook Control-W None
Brake the Rotor Control-X Service
Report Modem Configuration Control-Y None
Dump Setpoints Control-Z Service
Download Binary Event Log Menu Only None
Generate Test Alarm Menu Only Service
Generate Test Notice Menu Only Service
Load Default 50Hz Op Params to Flash Menu Only Service
Load Restricted default params to Flash Menu Only Service
Set Bearing Install Date to Current Time Menu Only Service