BEARING REAR 9M4880 - Caterpillar

Specifications
Illustration 1 g02342999
Table 1
SPECIFICATIONS FOR 349-4570 Fuel Filter Base    
Callout     Part Number     Part Name     Specification Description    
4     1R-0749     Fuel Filter     Lubricate the fuel filter seals with the fluid that is being sealed prior to installation. Use 185-3630 Strap Wrench to tighten the fuel filters
Torque to.........................
35 3 N m (26 2 lb ft)    
5     234-5013     Temperature Sensor     Torque to.........................
20 3 N m (177 27 lb in)    
6
7     325-8634     Pressure Sensor     Torque to.........................
10 2 N m (89 18 lb in)    
8     9S-4167     Hollow Stud     Apply Loctite 271 to the threads of the studs. Loctite 271 should cover the threads of the stud, shown as Distance (X), which is a measurement of
7.60 0.80 mm (0.30 0.03 inch).
Torque to.........................
70 15 N m (52 11 lb ft)    Removal Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     185-3630     Strap Wrench     1    
B     −     Loctite 271     −    
Turn the fuel supply to the OFF position and turn the power disconnect switch to the OFF.
Illustration 2 g02342941
Disconnect harness assemblies (1) .
Disconnect hose assemblies (2) .
Use Tooling (A) in order to remove fuel filters (4) from fuel filter base (3). Remove fuel filter base (3) .
Illustration 3 g02161001
Remove fuel temperature sensor (5). Remove pre-filter fuel pressure sensor (6) and remove post-filter fuel pressure sensor (7) .
Remove studs (8) from fuel filter base (3) .Installation Procedure
Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Install the fuel filters and the fuel filter base in the reverse order.
Lubricate the fuel filter seals with the fluid that is being sealed prior to installation.
Use Tooling (A) in order to tighten the fuel filters (4) to a torque of 35 3 N m (26 2 lb ft).
Illustration 4 g02342980
Apply Tooling (B) to the threads of studs (8). Tooling (B) should cover the threads of the stud, shown as Distance (X), which is a measurement of 7.60 0.80 mm (0.300 0.030 inch).
Tighten studs (8) to a torque of 70 15 N m (52 11 lb ft).