BELLCRANK 7V8523 - Caterpillar

Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below. Problem
The status screen in ET2007B v1.0 for the M322D, M322D MH, and M318D Wheeled Excavators indicates that the pitch sensor is not calibrated. There is no option on the calibration screen in order to calibrate the pitch sensor.Solution
The pitch sensor that is installed on D-Series Wheeled Excavators, interfaces with the machine controller in order to prevent machines that are configured for maximum travel speed (30 to 37 km/h (18.6 to 23 mph)) from overspeeding when the machine is traveling downhill. The travel speed for the M322D Wheeled Excavator is limited to 25 km/h (15.5 mph). As a result, pitch sensors are not installed and the pitch sensors cannot be calibrated. The calibration status for the pitch sensors for the affected machines will be removed in a future release of ET.