BELT 0617165 - Caterpillar

1. Disconnect and remove temperature sensor (1) from the air inlet manifold.2. Disconnect and remove pressure sensor (2) from the air inlet manifold.3. Disconnect air hose assembly (3) from the air inlet manifold.4. Remove twelve bolts (4) and the washers that hold the air inlet manifold in position. Remove air inlet manifold (5) and the three gaskets. The following steps are for the installation of the air inlet manifold.5. Check the condition of the three gaskets used between the cylinder head assembly and the air inlet manifold. If the gaskets are worn or damaged, use new parts for replacement.6. Put the three gaskets and inlet manifold (5) in position on the cylinder head assembly. Install twelve bolts (4) and the washers that hold it.7. Connect air hose assembly (3) to the air inlet manifold.8. Install pressure sensor (2) and temperature sensor (1) in the air inlet manifold. Tighten temperature sensor (1) to a torque of 20 .3 N m (15 .22 lb ft).