BELT-SERPENTINE 1834494 - Caterpillar

Electronic Subsystem Functional Tests
These tests are designed to establish whether a component and related parts are working correctly and if not, to pinpoint the faulty component.These tests may also be used for basic health checks, to determine if problems exist, or as a guide to check for intermittent problems.P-300: Inspecting Electrical Connectors
Many of the Operational Procedures and Diagnostic Code Procedures in this troubleshooting guide will direct you to check a specific electrical connector. Use the following steps to help determine if the connector is the cause of the problem. If a problem is found in the electrical connector, repair the connector and continue the test procedure.Functional Test
1. Check "DT" & "DRC" connector locking, and "HD" connector lock ring. Make sure that the connector is properly locked (clicked) together and that the two halves can't be pulled apart.2. Perform 10 pound (44 N) pull test on each pin/wire. Each pin and connector should easily withstand 10 pounds (44 N) of pull, and remain in the connector body. This test checks whether the wire was properly crimped in the pin, and whether the pin was properly inserted into the connector. The "DT" connectors use an orange wedge to lock the pins in place. Check to see that the orange wedge is not missing and installed properly on the "DT" connectors. Repair as needed. Pins should ALWAYS be crimped onto the wires; NEVER soldered. Use the Deutsch Crimp Tool (Cat P/N 1U5804).3. INSPECT CONNECTORS. Verify that pins and sockets are not corroded or damaged. Verify proper alignment and location of pins in the connector.4. CHECK INDIVIDUAL PIN AND SOCKET CONNECTIONS. This is especially important for intermittent problems. Using a new pin, insert the pin into each socket one at a time to check for a good grip on the pin by the socket. Repeat for each pin on the mating side of the connector, using a new socket for the test. P-301: Electrical Power Supply To The