BELT 1R1162 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     2P-8250     Strap Wrench As     1    
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Cleanliness is an important factor. Before you begin the removal procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g01878873
Close drain valve assembly (1) .
Illustration 2 g01878841
Open drain valve (6) in order to drain filter assembly (5). Use Tooling (A) in order to remove filter assembly (5).
Disconnect hoses (2). Remove bolts (3) and filter base assembly (4). Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     2P-8250     Strap Wrench As     1    
Illustration 3 g01878841
Install filter base assembly (4) and bolts (3). Connect hoses (2). Use Tooling (A) in order to install filter assembly (5). Close drain valve (6).
Illustration 4 g01878873
Open valve assembly (1) .