BELT 1R1267 - Caterpillar

Illustration 3 g01355439
Switch Assembly (2) Generator Switch (D-Series Machines) On D-Update Machines the Generator Switch is located at the 4th position of the switch panel.Before operating the magnet, make sure that the following conditions are met:
The installation status of the generator must be set to "installed" at the ET configuration screen.
The generator must be selected as the active tool in the monitor.
The generator switch (2) inside the cab, the main disconnect switch at the magnet controller must be in ON position.
The left armrest is in the lowered position.
The Implement Stop Function is deactivated on the Soft Switch Panel
The temperature of the hydraulic oil exceeds 15° C (59° F), to enable the generator system.
The speed of the generator is adjusted to a minimum of 1750 50 RPM.
The output voltage of the generator is adjusted to 240 5 VDC. The magnet cannot be connected to the system during this adjustment.
Illustration 4 g02445696
Home Screen of Operator Monitor (D-Series Update Machine)The Home screen of the Operator Monitor is displayed when the keyswitch for the machine is turned to the ON position. Press the "Menu" key to display the menu options.
Illustration 5 g02445699
Main Menu Screen of Operator Monitor (D-Series Update)Use the arrow buttons at the bottom of the Operator Monitor panel to select "Work Tool Select" from the "Main Menu" screen. Press the "OK" key, indicated at the bottom of the Operator Monitor panel.
Illustration 6 g02447656
Work Tool Select Screen of Operator Monitor (D-Series Update Machine)Use the arrow keys, located at the bottom of the monitor panel, to highlight the "Generator" function. When you return to the home screen, the "Generator" will be listed as the active tool.The machine control pattern is initially set at the factory to the SAE system, as shown. The pattern on the left pertains to the left joystick and the pattern on the right pertains to the right joystick. Note: Right Joystick positions (6) and (8) are not used in Material Handler applications.
Stick Out (1) - Move the joystick to this position in order to move the stick outward.
Swing Right (2) - Move the joystick to this position in order to swing the upper structure to the right.
Stick In (3) - Move the joystick to this position in order to move the stick inward.
Swing Left (4) - Move the joystick to this position in order to swing the upper structure to the left.
Boom Lower (5) - Move the joystick to this position to lower the boom.
Boom Raise (7) - Move the joystick to this position to raise the boom. HOLD (9) - When you release the joystick from any position, the joysticks will return to the HOLD position. Movement of the upper structure will stop.Two functions may be performed at the same time by moving a joystick diagonally. Left Implement Joystick
Illustration 7 g01919034
Left Joystick
Magnet OFF (Drop) (10) - Press the switch on the front of the left joystick in order to turn off the magnet.
Horn (11) - Press the left switch on the left joystick in order to activate the horn. Right Implement Joystick
Illustration