BELT-SERPENTINE 2498744 - Caterpillar

Machine Dimensions
Illustration 1 shows the dimensions of the machine that will need to be obtained in order for the AccuGrade system to operate correctly.Refer to the "Machine Dimensions - Configure" section of this document in order to obtain more information about the process to obtain the machine dimensions.
Illustration 1 g01113705
(A) Top of the lower housing height above right cutting edge bolt (B) Top of lower housing height above left cutting edge bolts (C) The distance that the receiver is back from the right bolts of the cutting edge. (D) The distance the receiver is back from left bolts of the cutting edge (E) Distance the GPS Receiver is in from right blade tip (F) Distance the GPS Receiver is in from left blade tip (G) Blade height (H) Blade width
You must enter correct dimensions. Any errors will transfer directly into the finished surface.
Note: Caterpillar recommends that you use the receiver measure up tool. If the measure up tool is not available, the height measurements should be made to the top of the lower housing on the GPS Receiver. Measure both the left and the right GPS Receivers.
Different offsets will be applied to the measured machine dimensions, depending on what option is selected in the "Measure height to" field. Selecting the wrong "Measure height to" option will introduce a vertical error of 73 mm (2.87 inch)