BELT-SERPENTINE 2867845 - Caterpillar

start by:a) remove rollover protective structure (ROPS) 1. Remove screws (1). Remove center panel (2) from the cab. 2. Remove screws (3). Pull panel (4) away from the cab.3. Disconnect wires from lighter (5) on the back side of the panel (left side panel only).4. Disconnect hose from diffuser (6) on the back side of the panel.5. Remove panel (4) from the cab.6. Do procedures 2 through 5 for the right side panel. 7. Loosen clamp and disconnect hose (7) from the washer nozzle.8. Disconnect three wires (9) and wiring harness (8). 9. Remove six bolts (10) that hold the front of the cab to the platform. 10. Open the window on the right side of the cab. Remove plugs (11). Remove the bolts that hold the cab to the platform. 11. Pull insulation (12) clear of the bottom of the cab on both sides.12. Remove bolts (13) from each side of the cab and put the insulation back into position in the cab. 13. Remove screws (15). Remove angle (14) from the back of the cab. 14. Remove bolts (16). Remove two strip assemblies (17) from the back of the cab. 15. Remove bolts (18) that hold the door frame to the platform. 16. Remove bolts (19). Remove strip (20) from the bottom of the door frame.17. Remove bolts (21) that hold the door frame to the platform. 18. Install tooling (A), chains and a hoist as shown. Remove cab (22) from the platform. The weight of the cab is 248 kg (550 lb.).Install Cab
1. Install tooling (A), chains and a hoist as shown. Put cab (1) in position on the platform. 2. Install strip (2) on the bottom of the door frame.3. Install bolts (3) that hold the door frame to the platform. 4. Install bolts (4) that hold door frame to the platform. 5. Install strip assemblies (5) on the back of the cab. 6. Install angle (6) on the back of the cab. 7. Pull insulation (7) clear of the bottom of the cab on both sides. Install the bolts that hold the cab to the platform. Put insulation (7) back into position in the cab.8. Open the cab window on the right. Install the bolts that hold the cab to the platform. 9. Install plugs (8) in the holes. 10. Install six bolts (11) that hold the cab to the platform.11. Connect hose (9) to the washer nozzle.12. Connect wire harness (12).13. Connect wires (10). 14. Put panel (14) in position in the cab.15. Connect the wires to lighter (13) (left side panel only).16. Connect the hose to diffuser (15).17. Install panel (14) to the cab.18. Do procedures 14 through 16 for the right side panel. 19. Install center panel (16) on the cab.end by:a) install rollover protective structures (ROPS)