BELT 3L7540 - Caterpillar

Removal Procedure for One Temperature Regulator
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the engine into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Disconnect the upper radiator hose from the water manifold.
Illustration 1 g00559394
Loosen hose clamps (2) . Remove bolts (1) . Remove regulator housing (3) .
Illustration 2 g00559396
Remove water temperature regulator (4) from regulator housing (3) .
Illustration 3 g00559403
Remove lip seal (5) from regulator housing (3) .
Illustration 4 g00593365
Remove gasket (7) from water manifold (6) . Do not reuse gasket (7) .
Illustration 5 g00593375
Remove bolts (8) from water manifold (6) .
Remove water manifold (6) and the gasket. Installation Procedure for One Temperature Regulator
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 6 g00593375
Position water manifold (6) with a new gasket on the cylinder head. Install bolts (8) .
Illustration 7 g00593365
Position a new gasket (7) on water manifold (6) .
Illustration 8 g00559403
Install lip seal (5) in regulator housing (3) . Ensure that lip seal (5) is fully seated in the counterbore of regulator housing (3) .
Illustration 9 g00559396
Install water temperature regulator (4) in regulator housing (3) .
Illustration 10 g00559394
Position regulator housing (3) with a new gasket on the water manifold. Install bolts (1) . Tighten bolts (1) to a torque of 50 9 N m (37 7 lb ft).
Position hose clamps (2) and tighten the clamps to a torque of 9 3 N m (80 27 lb in).Note: Refer to Specifications, "Water Lines" for more information on the position of hose clamps (3) .
Connect the upper radiator hose to the water manifold.
Fill the cooling system to the correct coolant level. Refer to Operation and Maintenance Manual, "Refill Capacities" in the Maintenance Section for more information.Removal Procedure for Two Temperature Regulators
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the engine into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Disconnect the upper radiator hose from the housing assembly.
Illustration 11 g02721175
Disconnect the harness assembly from coolant temperature sensor (2) . Remove coolant temperature sensor (2)