BIT-END RH 1359698 - Caterpillar

Removal Procedure
Start By:
Remove engine electronic control module.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Drain the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining procedures.
Illustration 1 g03705034
Graphic for reference only.
Remove bolts (1) and bracket (2). Disconnect hose assemblies (3).
Illustration 2 g03705041
Graphic for reference only.
Remove manifold assembly (6). Remove bolts (4) and engine oil cooler (5). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Clean the mating surfaces of the housing for the oil cooler and the cylinder block.
Illustration 3 g03316887
Illustration 4 g03705041
Graphic for reference only.
Install the engine oil cooler (5). Tighten bolts (4) to a torque of 22 N m (16 lb ft) in the sequence that is shown above. Install manifold assembly (6).
Illustration 5 g03705034
Graphic for reference only.
Connect hose assemblies (3). Install bracket (2) and bolts (1).
Fill the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct filling procedures. End By:
Install engine electronic control module.