BIT-END LH 1368756 - Caterpillar

1368756 BIT-END LH Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1368756
136-8756
1368756

Weight: 159 pounds 72 kg.

Buy BIT-END LH 1368756 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

SENSOR - FUEL FILTER FOR HYSTER: 1368756

$61.54

02 May 2021

US: EFI Equipment a

SENSOR - FUEL FILTER FOR HYSTER: 1368756
Parts Express HYSTER || All Brand new & rebuilt items comes with 1 year warranty. || SENSOR - FUEL FILTER. Category: HYSTER FORKLIFT PARTS. This part can also be found under the following part numbers: HY1368756 1368756 Â HYSTER 1368756 Â HYSTER1368756 1368756 Â Â . All Brand new & rebuilt items comes with 1 year warranty.

Number on catalog scheme:

Caterpillar 1368756 Parts scheme BIT-END LH

For full view, you need register

Information:

Separate Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 260-9412 Chain As 1
B 5P-6214 Track Block Assembly 2
C 5P-2379 Track Press Tool Gp 1
8S-7172 Double Acting Cylinder 1
8S-9903 Track Press Rollover Gp 1
Put the machine on a flat level floor.
The master pin of the track must be positioned above the center line of the sprocket or the idler.
Personal injury or death can result from grease and oil coming out of the relief valve.Grease and oil are under high pressure coming out of the relief valve and can penetrate the body.Do not watch the relief valve to see if grease is escaping. Watch the track or track adjustment cylinder to see if the track is being loosened. Make sure the vent holes are clean before the tension is released on the track.
Release the track tension. Refer to Operation and Maintenance Manual, "Track Adjustment - Adjust".
Illustration 1 g01167154
Use Tooling (A) to support track shoe (2). The weight of track shoe (2) is approximately 34 kg (75 lb). Remove bolts (1). Remove track shoes (2). Note: To provide additional clearance for the removal of the master pin, remove track shoe (2) on each side of the master pin.
Illustration 2 g01174955
Place Tooling (B) on the opposite ends of the track to prevent the track from sliding from the roller frame.
Illustration 3 g01999725
Use Tooling (A) and a suitable lifting device to support the section of track that is above Tooling (B). Use Tooling (C) to remove master pin (3). The weight of Tooling (C) is approximately 136 kg (300 lb). Use a suitable lifting device to raise the track from Tooling (B). Remove Tooling (B). Lower the track assembly.
Illustration 4 g01998554
Remove seals (4) from links (5).