BIT-END 1774551 - Caterpillar

that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, filters, and the installation of new components due to normal wear and aging. The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption, service hours and calendar time . Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Storage Procedure - Check
Fuel System - Prime
Daily
Air Tank Moisture and Sediment - Drain
Coolant Level - Check
Driven Equipment - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Walk-Around Inspection
Initial 20 to 40 Service Hours
Belts - Inspect/Adjust/Replace
Every Week
Battery Charger - Check
Every 250 Service Hours
Coolant Sample (Level 1) - Obtain
Grounding Stud - Inspect/Clean/Tighten
Initial 500 Service Hours
Engine Valve Lash - Check
Every Year
Coolant Sample (Level 2) - Obtain
Every 3000 Service Hours or 3 Years
Coolant (DEAC) - Change
Every 6000 Service Hours or 3 Years
Coolant Extender (ELC) - Add
Every 12 000 Service Hours or 6 Years
Coolant (ELC) - Change
PM Level 1 - Every 6625 L (1750 US gal) of Fuel or 250 Service Hours or 6 Months
Air Shutoff - Test
Alternator - Inspect
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fan Drive Bearing - Lubricate
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Radiator - Clean
PM Level 2 - Every 52 990 L (14 000 US gal) of Fuel or 2000 Service Hours or 1 Year
Aftercooler Core - Clean/Test
Aftercooler Core - Inspect
Engine Valve Lash - Check
PM Level 3 - Every 105 980 L (28 000 US gal) of Fuel or 4000 Service Hours or 2 Years
Coolant Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Mounts - Inspect
Every 132 475 L (35 000 US gal) of Fuel or 5000 Service Hours
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Overhaul
Overhaul Considerations