BIT & CUTTING EDGE GP 1U2210 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7573 Link Bracket 2 Start By:
Remove the combustion body group (ARD). Refer to Disassembly and Assembly, "Combustion Body Group (ARD) - Remove".
Remove the flywheel. Refer to Disassembly and Assembly, "Flywheel - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01266372
Fasten Tooling (A) and a suitable lifting device to flywheel housing (1). The weight of flywheel housing (1) is approximately 25 kg (55 lb).
Illustration 2 g01266373
Remove bolts (2) and bolt (3). Remove bolts (4).
Illustration 3 g01266377
Remove bolts (5) that fasten the engine oil pan to flywheel housing (1). Remove flywheel housing (1). Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 138-7573 Link Bracket 2
B 1U-8846 Sealant -
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Apply Tooling (B) to the entire mounting face of the flywheel housing prior to installation.
Illustration 4 g01266372
Fasten Tooling (A) and a suitable lifting device to flywheel housing (1). The weight of flywheel housing (1) is approximately 25 kg (55 lb). Position flywheel housing (1) on the cylinder block.
Illustration 5 g01266377
Install bolts (5) that fasten the engine oil pan to flywheel housing (1).
Illustration 6 g01266373
Install bolts (4). Install bolt (3). Install bolts (2).
Check the flywheel housing runout. Refer to the Testing and Adjusting, "Flywheel Housing - Inspect". End By:
Install the flywheel. Refer to Disassembly and Assembly, "Flywheel - Install".
Install the combustion body group (ARD). Refer to Disassembly and Assembly, "Combustion Body Group (ARD) - Install".