BIT-END 5J6928 - Caterpillar

The Electronic Control Module (ECM) monitors the operating parameters of the engine. The ECM can initiate responses if a specific engine parameter exceeds an acceptable range. Three possible responses may be available for each parameter: , DERATE and SHUTDOWN. Some of the responses are not available for some of the parameters. Use the Caterpillar Electronic Technician (ET) to perform the following activities for the monitoring system:
Parameter programming
Response configuration
Set delay timesThe default settings for the parameters are programmed at the factory. To accommodate unique applications and sites, some of the parameters may be reprogrammed with Cat ET. The screens of Cat ET provide guidance for the changing of trip points.Note: Some parameters require no password in order to be changed. Other parameters can be changed with customer passwords. Some of the parameters are protected by factory passwords. There are some parameters that cannot be changed.Changing the Settings of the Monitoring System
Use the following procedure to change settings of the parameters:
Select the "Service/Monitoring System" screen on Cat ET.
Highlight the desired parameter. Then click the "Change" button in the lower left corner of the screen.The "Change Monitor System" screen will appear.
Change the "State" of the parameter.
Set the "Trip Point" and the "Delay Time" according to the "Allowed Values" that are displayed in the lower half of the screen.
Click the "OK" button.If a password is required, the "Enter Passwords" screen will appear. Enter the correct passwords and then click the "OK" button.Note: If a factory password is required, the "Enter Factory Passwords" screen will appear. Refer to Troubleshooting, "Factory Passwords" for information that is related to obtaining factory passwords.The new settings will be effective immediately.Default Settings of the Monitoring System
The default settings for the programmable parameters are listed in Table 1. The values of the parameters may have already been changed. Use the Cat ET to determine the programming for your engine. Many of the items can be reprogrammed in order to accommodate the requirements of individual applications.Parameters for the Programmable Monitoring System
Table 1
Default Settings of the Programmable Monitoring System    
Parameter    Action    Default State    Security Level
Password    Trip Point    Range    Delay in Seconds    Range of the Delay in Seconds    
E073 High Oil Filter Differential Pressure     Warning     Always On     None     103 kPa (15 psi)    
80 to 138 kPa (11 to 20 psi)     10     1 to 60    
Shutdown
138 kPa (20 psi)    
E197 High Engine Oil Temperature     Warning     Always On     None    
102 °C (216 °F)    
80 to 102 °C (176 to 216 °F)     20     1 to 60    
Shutdown
104° C (219° F)    
85 to 104 °C (185 to 219 °F)
E199 Low Coolant Temperature     Warning     On     None    
5 °C (41 °F)    
5 to 80 °C (41 to 185 °F)     20     1 to 60    
E337 High Engine Oil to Engine Coolant Diff Temp     Warning     Always On     None    
14 °C (57