BIT-END 5J6941 - Caterpillar

5J6941 BIT-END Caterpillar parts 4A, 4S, 930, D4E, D4E SR

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA5J6941
5J-6941
5J6941

Weight: 0.010 pounds 0 kg.

Buy BIT-END 5J6941 Caterpillar genuine, new aftermarket tractor parts with delivery
BULLDOZER, WHEEL LOADER,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

5J6941 cutting edge,end, L/HFor Cat Models

$61.37

11 May 2018

Paint Valley: Paint Valley

5J6941 cutting edge,end, L/HFor Cat Models
High Quality Aftermarket Replacement Part || Fits Models: MUO: (E70, E70B, 307, 307B, 307C, 307SSR) || Fits Brands: Cat || 5J6941 || 5J6941 cutting edge,end, L/HFor Cat Models

5J6941 Cutting Edge, End, L/H Aftermarket Made to fit Cat D4. Not Created or Sold by Cat.

$37.50

06 Oct 2021

US: IronDT

5J6941 Cutting Edge, End, L/H Aftermarket Made to fit Cat D4. Not Created or Sold by Cat.
PVE Cutting Edge, End, L/H Cat D4

Show more prices Caterpillar parts

Number on catalog scheme: 17

For full view, you need register

Compatible equipment models: 5J6941:

BULLDOZER 4A 4S

TRACK-TYPE TRACTOR D4E D4E SR

WHEEL LOADER 930 Caterpillar

Information:

This diagnostic code is recorded when the PL522 or 523 detects a problem that is internal to the control module. This diagnostic code can only be caused if the ECM for PL522 or 523 is faulty. There are no serviceable parts within the control module.Test Step 1. CHECK THE HARNESS CONNECTIONS.
Disconnect the contacts and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the key start switch to the ON position.
Operate the machine.
Determine if "CID 0254 FMI 12" diagnostic code is present by using Cat ET . Expected Result:The "CID 0254 FMI 12" diagnostic code is present.Results:
OK - The "CID 0254 FMI 12" diagnostic code is present.Repair: The problem has not been corrected. ECM failure is unlikely. Perform this diagnostic test procedure again. If the cause of the diagnostic code is not found, replace the PL522 or 523 ECM. Before replacing the PL522 or 523, contact your Caterpillar Technical Communicator. Refer to Systems Operation, Troubleshooting, Testing and Adjusting , "Electronic Control Module (ECM) - Replace".STOP
NOT OK - The "CID 0254 FMI 12" diagnostic code is not present. The problem does not exist at this time. The initial problem was probably caused by a poor electrical connection or a short at one of the harness connectors that was disconnected and reconnected. Resume normal machine operation.STOP