BIT GP 6Y4339 - Caterpillar

Perform the procedures that are described in this Operation and Maintenance Manual, "Before Starting Engine" topic (Operation Section).
Start the engine according to the instructions in this Operation and Maintenance Manual, "Engine Starting" topic (Operation Section).
For any type of leak (coolant, lube, or fuel) clean up the fluid. If leaking is observed, find the source and correct the leak. If leaking is suspected, check the fluid levels more often than recommended until the leak is found or fixed, or until the suspicion of a leak is proved to be unwarranted.
Perform an inspection of the installation after the engine is started. Look for leaks. Listen for unusual noises.
Check the engine oil level when the engine is operating at low idle rpm. Observe the oil level on the "LOW IDLE" side of the oil level gauge (dipstick).
Inspect the lubrication system for leaks at the oil pan, the oil filter, and the valve covers.
Inspect the cooling system for leaks at the hose connections.
Inspect the piping for the air inlet system and the elbows for cracks and for loose clamps.
Inspect the exhaust system for leaks.
If the enclosure has louvers, inspect the louvers for proper operation.
Observe the gauges. Ensure the correct readings for the engine rpm. Record the data for the gauges.
Record the data for the performance of the generator. See the Operation and Maintenance Manual for the generator and the control panel.
After exercising the generator set, stop the engine according to this Operation and Maintenance Manual, "Engine Stopping" topic (Operation Section).
Perform the procedures that are described in this Operation and Maintenance Manual, "After Stopping Engine" topic (Operation Section).
Ensure that the control switches are in the correct position for automatic starting of the generator set.