BIT & CUTTING EDGE GP 9W3762 - Caterpillar

TYPE="TABLE" @@@-->
Illustration 1 g01623054
(1) Start switch
(2) Diagnostic lamp
(3) Emergency stop button
(4) Circuit breaker reset The standard control panel has the following features:
Manual Circuit Breaker Reset
Diagnostic Lamp
Automatic Circuit Breaker Reset
Emergency Stop Button
Start SwitchThe control panel is mounted to the side of the engine that is used for service of the engine.When the switch is turned to the START position, the starting motor magnetic switch is energized. The electric starting motor is engaged. The starting motor will continue to crank while the start switch is held in the START position. The start switch is spring loaded in order to return to the RUN position when the start switch is released. The engine may be shut down by turning the start switch to the OFF position. This mode of shutdown removes power to the ECM.Start Switch (1) - The start switch has three positions: OFF, RUN and START. When the start switch is turned clockwise to the RUN position, the lamps will flash for 5 seconds during the system test. The lamps will then shut off. In the RUN position, the ECM and electronic systems are powered up.Diagnostic Lamp (2) - This lamp will flash when a diagnostic code has been generated by the Electronic Control Module (ECM). The active diagnostic code will flash.Emergency Stop Button (3) - The OUT position is for normal engine operation. Push the emergency stop button in order to stop the engine during an emergency. The start switch will not energize the starting motor magnetic switch while the emergency stop button is depressed. The emergency stop button must be reset before the engine can be started. Turn the emergency stop button clockwise in order to release and allow start-up.Circuit Breaker Reset (4) - Check the circuit breaker reset button (15 amps) on the control panel if the engine looses all electrical power.