BIT & CUTTING EDGE GP 9W8619 - Caterpillar

Box Group Assembly
Illustration 38 g03717161
Install sensor (9) to bracket assemble (10) using two washers (13) and two nuts (12). Tighten nuts to a torque of 12 3 N m (9 2 lb ft).Installing Stable Blade Control
Illustration 39 g03746950
Install box group (1) using four washers (16), and four bolts (17) .
Illustration 40 g03717188
Install clip (11) and secure using cable strap (14) .
Illustration 41 g03727756
Note: Remove 439-5510 Plug As from radiator guard harness before connecting stable blade harness.
Connect harness assembly (3) to existing harness assembly (J) .
Illustration 42 g03727779
Orient harness assembly (3) as shown in Illustration 42 with coupling facing towards the front of the machine. Secure harness assembly (3) to the machine using existing flanges, washers, and bolts.
Illustration 43 g03648506
Install clip (4), clip (5), and grommet (6) on harness assembly (3). Secure harness assembly (3) using plate assembly (2), three washers (8), and three bolts (7) .
Illustration 44 g03652976
(H) 30°
When installing harness assembly (3), position harness assembly (3) to dimension (H) .
Illustration 45 g03746952
Install harness assembly (3). Install two flanges (17), four bolts (18), and four washers (16). Install grommet (20) and secure using cable strap (21) .
Illustration 46 g03746955
Install cover (19) using four washers (16), and four bolts (15) .
Check the oil level in the hydraulic tank. If necessary, fill the hydraulic tank. Cycle the cylinders to full stroke in both directions in order to purge air from the lines and from the cylinders. Check the level in the hydraulic tank again. Refill the hydraulic tank to the "FULL" mark.
After assembly is complete, prepare the machine for operation. Refer to the Operation and Maintenance Manual for instructions.Note: Stable blade option must be activated using the "Display" or "Electronic Technician" for the function to work.