BLADE AS-SEMI-UNIVERSAL 1362751 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     138-7573     Link Bracket     2    
B     FT2711     Special Bolt     2    
C     FT2712     Guide Stud     2    
Support the engine with blocks or a suitable lifting device.
Illustration 1 g01020856
Install Tooling (A) on the flywheel. Fasten a suitable lifting device to the flywheel.
Remove one bolt (1) and the washer. Remove another bolt (1) and the washer that is 180 degrees from the first bolt. Replace the bolts with Tooling (C) .
Remove remaining bolts (1) and the washers.
Remove flywheel (3). Slide the flywheel off the guide studs. The weight of the flywheel is approximately 57 kg (125 lb).Note: If your engine is equipped with a Rear Power Take-Off RPTO you need to reinstall Tooling (B). This procedure will hold the gear tight against the end of the crankshaft.
Inspect flywheel ring gear (2). Replace the ring gear, if necessary. Place the flywheel on a wood block. Use a hammer and a punch in order to remove the ring gear.