BLADE GP-ANGLING 1771982 - Caterpillar

1. Remove the shaft (2) from the carrier (3).2. Remove dowel (1) from the shaft (2).3. Remove the weights (4) from the carrier (3) by removing the dowels (5). 4. Remove the ring (10) from the thrust collar (6).5. Remove a race (9), a bearing (8), and a race (7) from the thrust collar (6). 6. Remove the two bolts (12) that hold the lever (14) to the shaft (13). Slide the shaft (13) out of the governor housing and remove the lever (14) and the washers (11) between the lever and the housing. 7. Remove the seal (15) from the governor housing.Assemble Governor
1. Use tooling (A) to install the seal in the governor housing with the lip of the seal toward the inside of the housing. 2. Put the lever (2) in position in the governor housing with a washer (1) between the lever (2) and the housing at each side.3. Slide the shaft (3) into position and install the two bolts that hold the lever (2) to the shaft (3). 4. Install a race (5), a bearing (6), a race (7), and a ring (8) on the thrust collar (4). 5. Install the weights (12) on the carrier (11) with the dowels (13).6. Install dowel (9) in the shaft (10).7. Install the shaft (10) in the carrier (11). end by: a) connection of governor to fuel injection pump housing