BLADE AS-SEMI-UNIVERSAL 2394170 - Caterpillar

Disassembly Procedure
Start By:
Remove the solenoid valve. Refer to Disassembly and Assembly, "Solenoid Valve (Extender Extend) - Remove".
Remove the solenoid valve. Refer to Disassembly and Assembly, "Solenoid Valve (Extender Slope) - Remove".Note: Cleanliness is an important factor. Before you begin the disassembly procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform disassembly procedures on a clean work surface. Keep components covered and protected at all times.
Illustration 1 g00800980
Remove bolts (2) and valve block (1) .
Illustration 2 g00800982
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Remove plugs (3), O-ring seals (4), pins (5), springs (6), check balls (7), caps (8), and valve (9) from valve block (1) .
Illustration 3 g00800983
Remove O-ring seals (10) from valve body (11) .
Illustration 4 g00800984
Remove bolts (13), end plate (14), and solenoid (12) .
Illustration 5 g00800985
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Remove sleeve (17), spring (16), and sleeve (15) .
Remove spool (18) from valve body (11) .
Illustration 6 g00800986
Remove O-ring seal (19) from spool (18) .
Illustration 7 g00800988
Remove spring (23) and spring seat (22) from valve body (11) .
Remove spool (21) from valve body (11) .
Repeat Steps 4 through 8 in order to remove solenoid assembly (20) .